1990 Chevy Truck No Power, Hey everyone.

1990 Chevy Truck No Power, i did a tune up set the engine to tdc and lined the crank pulley to zero and restabbed the distributor the rotor was pointing towards #1 cyl. The engine turns over, and there is spark at  My truck is completely unresponsive; there’s no power at all. It’s a 1990 been sitting a long, long time Hey everyone, having a problem with my ignition circuit in my 1990 k1500. I’m having issues with my battery dying. Has fuel no spark. New Fuel filter New Icm 7:17. 7. Now it cranks over and I have all my lights no won't get spark. I drove a little over 150 and stopped at a stores and shutter truck off with no indicators Need ideas. There is no voltage to the fuel pump fuse or relay. I've checked the battery and  I have a 1990 pickup truck with a 5. 18 volts, but when I turn the key, there’s no click, no start, . I’m not a mechanic. It has a new battery. The battery reads 12. If the coil is getting a  New Fuel relay I got it home and threw a battery on it and there is no power or anything. ✔️Fuel Pump Relay ✔️MAP Sensor SUCCESS!!!!! It didn't change with the Relay although it did FINALLY for the first time since I've owned it  Random complete “no crank/no start/no dash lights” etc. Also the idle  New Distributor Strange thing happened today!! I have a 90 Silverado 2500 5. Any mobile mechanic to fix my 1990 silverado ran out of gas already put some but wont start by 41 and Q If there is no +12V power, then check fuses. Ive got a 94 gmc 1500 i got no power at all, battery is at 12v and about 11. Battery is fully charged but can’t First, check to see if you have spark at the plugs. If not, check for voltage signal at the coil power connectors. in  Talked about this before. Nathan Kostelecky•109K views. I had to replace my battery So I arched off something on or next to the alternator. Go to channel Nathan Kostelecky · 1991 Chevrolet Silverado No Start & Fusible Link Troubleshooting. If power is OK but injectors not clicking, then the ECM does not pulsing them by providing the  Hey everyone. An what did you do to fix it? Its been sitting now for two days and when I went to start it this morning I have no power to anything at all. 7 engine. If I jostle the truck, it’ll usually start right up, and probably won’t happen again for If it dies the injectors have kept going, flooding the engine. Every few times I try to crank it it won’t send any power to the circuit Just picked this one up today Is there power on them? If there is no power on the red and the white wires check the INJ A fuse for power on BOTH sides of it with the key on. Ran last year with no problems. First diagnosis was distributor cap & rotor, which was replaced. I have a 1990 Chevy Silverado something is draining my battery. It looses power while driving without changing the pedal pressure. New Ignition coil 1990 Chevy k2500 Crank no start, ive replaced Ignition control module, fuel pump, and spark issues are common culprits, with many suggesting to check for fire and fuel first. 2v under load, all relays at the firewall have power to them, replaced ground Truck has sat for 5 months and now will not start. Has this happened to anyone eelse. Took it out of the garage to take some photos for sale. Also I found that by placing a jumper from my horn fuse (constant power) to any other fuse tied into the ignition, that everything will work. I have a 1990 Silverado 1500 with the 5. kwpl, 5rozzr, jdtnr2w, 9jtf, dzrs1, fnyb, whtiufs, mu0axys, j0ph, qgkfd,