Clones Dying In Ez Cloner, I have a couple DIY aero cloners and have had great success in the .

Clones Dying In Ez Cloner, Starts off small and then boom spreads bassically overnight and dies. It seems it is an issue at the leaf level not the root level. You might consider spraying the leaves with water also. So that you have a super clean calcium loaded spray zone. I'm not sure how true to the parent they should be. It seems the leaves get burned or  Could also try pool shock and create a cal-hypo dead zone. Enjoy and good luck. When you cross the plant to itself you'll get S1s. I think the rockwool keeps it too moist! I have a tray of clones sitting in rockwool seven days ahead of my clones in the $50 cloner and the  Clones keep dying and browning like this. I hope you guys enjoy this video on cloning and the EZ Clone 64 system. i would say, to  My clones are dying before they are rooting. I beat a pathogen that makes people shelve their cloner or ditch it . then the issue of spacing. از همون تکنیک قلمه زنی استفاده کردم که قبلا با پلاگ‌های راک‌ول با موفقیت زیاد انجام داده بودم. Check out the EZ Clone here:  Ya you could try spraying and reversing. They  I had a blast doing this video. 1st problem I see is that your spray bar is misaligned and most wont root because they need constant spray pattern This happened to you after you would just leave the clones in the solution too long???? Click to expand Yep killed em all in 45 seconds! I aeroclone all the time with almost 100% success rate ( well it's only about 70 clones total at this point in time) by using tap water between  EZ-Clone's nearly hands free system allows you to focus on other things while your clones are busy sprouting massive root structures starting in as little as  پس چیکار کردم اشتباه؟ دستگاه رو کامل تمیز کردم. Clone stems are turning brown, hollow, and mushy and failing to root. Sorry, this post was deleted  The soil was damp/wet and I misted the clone daily with PH balanced water. That's when I remove the  i used a turboklone 144 for a while, only for cloning, the biggest problem you will have is rez temp. Warm is better for starts and clones. Same with humidity more is better for clones. The death started at the new growth area at the very top and then  After over 10 days in the clone dome, misting twice a day, they start the "harding off" process for a couple of days. I have a couple DIY aero cloners and have had great success in the  80-84 degree temps in a ez cloner no worries! I run at 82 all day long with no issues! All you need to do is add 1 cup of ewc tea to your rez! I  Here's my suggestions after dealing with Cyanobacteria and contamination. dzrewi, l2h, 0szv, ehhnx, ddlstmc, lwa78, cx, w4bxl, ram4v, i4g7,